I went out to the hangar to fabricate the Tip brace tubes. I misplaced one of my faceplate protectors, so I used a paint scraper. This keeps vice marks off of the al tubing. .5 hrs.
I'm back in the basement with the wing. It's too cold to be in the hangar. I don't want to pay for the propane to warm up the shop. It's 10 degrees today. Above are the lift strut brackets. I had to use a threaded angle #30 bit to get under the anti-drags tube, and a long #30 bit to get past the tiedown loop. 2 hrs.
No comments:
Post a Comment