Monday, December 18, 2017

Heated Shop



In August we decided to enclose the back 16 ft. of our 50X60 hangar.  We went with 10 ft. ceilings.  2X10 full span rafters 16" on center, with blown in R-19ish insolation.  We installed a Mr Heater 50,000 btu propane heater.  An 8 X 12 foot cannon ball sliding barn door separates the shop from the unheated hangar.  We installed a man door in the slider. Finished the first week of December.

After we finish the Left Wing in the basement this winter, my wife can again have here basement back!

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)
  • Rivet holes drilled and Oratex has arrived!
    My 15 year old, Robby drilling out all of the fabric rivet holes. My Oratex arrived,  Missing an end, but all appears to be in orde...
  • Lift Strut bracket and Aileron/Flap hanger slots
    Front Strut Bracket Hysoled and riveted in place.  Leading Edge Hysoled in place as well.  I took a 5/8s Forstner Drill bit to c...
  • Introduction
    Aircraft:       JustAircraft Highlander #393 Modifications:     Extreme Landing gear                             TK pneumatic Tailwheel ...